Comments on: V3 Build 6 http://www.grzsoftware.com/blog/development/v3-build-6/?utm_source=rss&utm_medium=rss&utm_campaign=v3-build-6 Fri, 12 Aug 2011 12:57:41 +0000 hourly 1 http://wordpress.org/?v=3.3 By: Randy http://www.grzsoftware.com/blog/development/v3-build-6/#comment-7878 Randy Thu, 15 Oct 2009 05:43:06 +0000 http://www.grzsoftware.com/news/2009/10/14/v3-build-6/#comment-7878 Nope, sorry, got the colors mixed up. Top clearance plane is OK, bottom is whacked. I'll email you screenshots. Nope, sorry, got the colors mixed up. Top clearance plane is OK, bottom is whacked. I’ll email you screenshots.

]]> By: Randy http://www.grzsoftware.com/blog/development/v3-build-6/#comment-7877 Randy Thu, 15 Oct 2009 05:41:17 +0000 http://www.grzsoftware.com/news/2009/10/14/v3-build-6/#comment-7877 OK Robert, you asked for it. :) I always use top of material for z=0 to be able to coordinate with SheetCam and my own gcode. And it is the logical zero for two-sided machining. I've never used anything else. But load up a file for two-sided machining and put the origin about 1/3 way down the geometry. In my initial test, the top retract plane was at the top of the stock, and the bottom retract plane was way up in midair. Stabilize that. ;) OK Robert, you asked for it. :)

I always use top of material for z=0 to be able to coordinate with SheetCam and my own gcode. And it is the logical zero for two-sided machining. I’ve never used anything else.

But load up a file for two-sided machining and put the origin about 1/3 way down the geometry. In my initial test, the top retract plane was at the top of the stock, and the bottom retract plane was way up in midair.

Stabilize that. ;)

]]>