Toolpath Update
The new ZMap-free finishing code is still in progress. I have only two types tool left to code, straight and tapered endmills with a corner radius. These are probably the most difficult because the math defining a torus is complicated.
If I can get this done within the next 3-4 days then I should be able to get the new finishing path done in the next few weeks. So far it’s not very fast but I haven’t had much time to dedicate to optimization. Hopefully any loss in speed will be more than offset by using less memory and only having to calculate the actual toolpath, not all the extra information that is currently calculated that is not directly part of the output path.