Build 5946
I just uploaded a new version that fixes a new bug I found. Under certain circumstances the finish stepover may be wrong depending on the oversampling value. This got introduced in the last couple of releases and I’m shocked that nobody reported it.
Also, I’m just finishing up a new web site. The current one hasn’t been touched much in the past three years so it’s about time to redo it. I’m probably less that a week from being done but I’ll probably post a link if the forum for feedback before that. Included in the new site will be the MeshCAM Art release and a new payment processor, 2Chechout.com. Paypal will remain but those who don’t like them can choose 2Checkout. I hope that those who dislike Paypal will like this option.
Comments
3 Responses to “Build 5946”
Correction, I emailed that to the Yahoo group where it’s message 2469 in the email archive.
Randy
My comments are disappearing! My original comment, which I corrected above, said that I had emailed you directly about a stepover bug I found in build 5934. I never use zero oversampling myself, so I haven’t noticed that bug since then. Is that the one you found?
Randy
Sorry- I must have missed that one. The stepover would have changed depending on several variables but usually when the finish zmap ended up being very coarse. Having seen the settings you mill with I doubt it would have been a problem for you.
-Robert