Slicing
September 30, 2007 · Filed Under MeshCAM Development
If you’ve been following the support group you’ve see that there’s been a lot of discussion about adding the slicing mode that was in version 1.18. I removed it in V2 with the intention of adding it back in but never got around to it. Yesterday I began writing code for the new slicing mode and came across the old disabled command from 1.18. I reenabled it and, to my surprise, it worked well. The old dialog did not support mm and inch input so I had to fix that. The images were not up to my current standards so I redid those as well. If my testing goes well it could be released within a week or so.