GRZ Software Blog

News and tips for MeshCAM

V6 Almost Ready

I just uploaded what I hope will be the last build of V6 before I make it an official release. This happened to be a big change- at the last minute I decided to change to Visual Studio 2013 from Visual Studio 2005. My thinking was that C++ has advanced a lot in the last 10 years and MeshCAM can benefit from the new C++11 features. To use this features, I needed to move to a new compiler.

I’d really appreciate any feedback you can give for MeshCAM V6 Build 11, even an email that says “Tried build 11, works fine” is helpful. If the feedback is good then I can finally remove V5 as the “Release” version.

Comments